Makita HR140 Instruction Manual

Also see for HR140: Instruction manual

6 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: HR140DDrilling capacities Concrete 14 mmSteel 10 mmWood 13 mmNo load speed 0 - 850 min -1Blows per minute 0 - 4,900 min -1Overall length 246 mmRated voltage D.C. 10.8 V - 12 V maxStandard battery cartridge BL1015 / BL1016 / BL1020B / BL1021B / BL1040B / BL1041BNet weight 1.9 - 2.6 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications and battery cartridge may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Intended useThe tool is intended for hammer drilling and drilling inbrick, concrete and stone.It is also suitable for drilling without impact in wood,metal, ceramic and plastic.NoiseThe typical A-weighted noise level determined accord-ing to EN60745:Sound pressure level (L pA ) : 84 dB(A)Sound power level (LWA ) : 95 dB (A)Uncertainty (K) : 3 dB(A)WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN60745:Work mode: hammer drilling into concreteVibration emission (ah, HD): 6.5 m/s2Uncertainty (K) : 1.5 m/s2Work mode: drilling into metalVibration emission (ah,D) : 3.0 m/s2 or lessUncertainty (K) : 1.5 m/s2NOTE: The declared vibration emission value hasbeen measured in accordance with the standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission valuemay also be used in a preliminary assessment ofexposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in which thetool is used.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when it isrunning idle in addition to the trigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.SAFETY WARNINGSGeneral power tool safety warningsWARNING: Read all safety warnings, instruc-tions, illustrations and specifications providedwith this power tool. Failure to follow all instructionslisted below may result in electric shock, fire and/orserious injury.Save all warnings and instruc-tions for future reference.The term "power tool" in the warnings refers to yourmains-operated (corded) power tool or battery-operated(cordless) power tool.