4ENGLISHExplanation of general viewSPECIFICATIONS• Due to our continuing programme of research and development, the specifications herein are subject to change withoutnotice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003END201-5SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use..... Read instruction manual............... DOUBLE INSULATIONENE041-1Intended useThe tool is intended for hammer drilling in brick, concreteand stone.ENF002-2Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, and canonly be operated on single-phase AC supply. They aredouble-insulated and can, therefore, also be used fromsockets without earth wire.GEA005-3General Power Tool SafetyWarningsWARNING! Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in electric shock, fire and/orserious injury.Save all warnings andinstructions for future reference.The term “power tool” in the warnings refers to yourmains-operated (corded) power tool or battery-operated(cordless) power tool.Work area safety1. Keep work area clean and well lit. Cluttered or darkareas invite accidents.2. Do not operate power tools in explosiveatmospheres, such as in the presence offlammable liquids, gases or dust. Power toolscreate sparks which may ignite the dust or fumes.3. Keep children and bystanders away whileoperating a power tool. Distractions can cause youto lose control.Electrical safety4. Power tool plugs must match the outlet. Nevermodify the plug in any way. Do not use anyadapter plugs with earthed (grounded) powertools. Unmodified plugs and matching outlets willreduce risk of electric shock.5. Avoid body contact with earthed or groundedsurfaces such as pipes, radiators, ranges andrefrigerators. There is an increased risk of electricshock if your body is earthed or grounded.6. Do not expose power tools to rain or wetconditions. Water entering a power tool will increasethe risk of electric shock.7. Do not abuse the cord. Never use the cord forcarrying, pulling or unplugging the power tool.Keep cord away from heat, oil, sharp edges ormoving parts. Damaged or entangled cords increasethe risk of electric shock.1. Switch trigger2. Side grip3. Bit shank4. Bit grease5. Bit6. Chuck cover7. Depth gauge8. Clamp screw9. Grip base10. Drill chuck11. Chuck adapter12. Commutator13. Insulating tip14. Carbon brush15. Screwdriver16. Brush holder cap17. Lock nut wrench18. Crank cap19. Hammer greaseModel HR2010CapacitiesConcrete 20 mmSteel 13 mmWood 24 mmNo load speed (min -1) 0 - 900Blows per minute 0 - 4,000Overall length 302 mmNet weight 3.4 kgSafety class /II