2ENGLISHSPECIFICATIONSModel HR2230Concrete 22 mmCore bit 54 mmDiamond core bit (dry type) 65 mmSteel 13 mmCapacitiesWood 32 mmNo load speed (min -1) 0 - 1,050Blows per minute 0 - 4,050Overall length 357 mmNet weight 2.4 kgSafety class /II• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.• Note: Specifications may differ from country to country.END201-2SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.・ Read instruction manual.・ DOUBLE INSULATION・ Only for EU countriesDo not dispose of electric equipmenttogether with household waste material!In observance of European Directive2002/96/EC on waste electric andelectronic equipment and itsimplementation in accordance withnational law, electric equipment thathave reached the end of their life mustbe collected separately and returned toan environmentally compatiblerecycling facility. ENE042-1Intended useThe tool is intended for hammer drilling and drilling inbrick, concrete and stone.It is also suitable for drilling without impact in wood,metal, ceramic and plastic. ENF002-1Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated in accordance with EuropeanStandard and can, therefore, also be used from socketswithout earth wire.ENG102-1For European countries onlyNoiseThe typical A-weighted noise level determined accordingto EN60745-2-6:Sound pressure level (LpA) : 89 dB(A)Sound pressure level (LWA) : 100 dB(A)Uncertainty (K) : 3 dB(A)Wear ear protection ENG303-1Work mode : hammer drilling into concrete, 10 mmdiameter and 100 mm depthVibration emission (ah,HD) : 15 m/s 2Uncertainty (K) : 1.5 m/s 2ENH101-7EC-DECLARATION OF CONFORMITYModel; HR2230We declare under our sole responsibility that thisproduct is in compliance with the following standards ofstandardized documents;EN60745, EN55014, EN61000 in accordance withCouncil Directives, 2004/108/EC, 98/37/EC.CE2006000230Tomoyasu KatoDirectorResponsible Manufacturer:Makita Corporation3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPANAuthorized Representative in Europe:Makita International Europe Ltd.Michigan Drive, Tongwell, Milton Keynes, Bucks MK158JD, ENGLAND