4hidden wiring or its own cord. Cuttingaccessory contacting a "live" wire may makeexposed metal parts of the power tool "live" andcould give the operator an electric shock.4. Wear a hard hat (safety helmet), safety glassesand/or face shield. Ordinary eye or sunglasses are NOT safety glasses. It is alsohighly recommended that you wear a dustmask and thickly padded gloves.5. Be sure the bit is secured in place beforeoperation.6. Under normal operation, the tool is designedto produce vibration. The screws can comeloose easily, causing a breakdown or accident.Check tightness of screws carefully beforeoperation.7. In cold weather or when the tool has not beenused for a long time, let the tool warm up for awhile by operating it under no load. This willloosen up the lubrication. Without properwarm-up, hammering operation is difficult.8. Always be sure you have a firm footing.Be sure no one is below when using the tool inhigh locations.9. Hold the tool firmly with both hands.10. Keep hands away from moving parts.11. Do not leave the tool running. Operate the toolonly when hand-held.12. Do not point the tool at any one in the areawhen operating. The bit could fly out andinjure someone seriously.13. Do not touch the bit or parts close to the bitimmediately after operation; they may beextremely hot and could burn your skin.14. Some material contains chemicals which maybe toxic. Take caution to prevent dustinhalation and skin contact. Follow materialsupplier safety data.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto safety rules for the subject product. MISUSE orfailure to follow the safety rules stated in thisinstruction manual may cause serious personalinjury.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Switch action12010155CAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly and returnsto the "OFF" position when released.To start the tool, simply pull the switch trigger. Tool speedis increased by increasing pressure on the switch trigger.Release the switch trigger to stop. For continuousoperation, pull the switch trigger and then push in thelock button. To stop the tool from the locked position, pullthe switch trigger fully, then release it.Reversing switch actionB1A010156CAUTION:• Always check the direction of rotation beforeoperation.• Use the reversing switch only after the tool comesto a complete stop. Changing the direction ofrotation before the tool stops may damage the tool.• When you operate the tool in counterclockwiserotation, the switch trigger is pulled only halfwayand the tool runs at half speed. Forcounterclockwise rotation, you cannot push in thelock button.This tool has a reversing switch to change the direction ofrotation. Move the reversing switch lever to theposition (A side) for clockwise rotation or to the1. Reversing switchlever1. Lock button2. Switch trigger