Makita KP0800 Instruction Manual

Also see for KP0800: Instruction manual Manual Instruction manual Technical information Instruction manual

Contents

48. Keep hands away from rotating parts.9. Before using the tool on an actual workpiece,let it run for a while. Watch for vibration orwobbling that could indicate poor installationor a poorly balanced blade.10. Make sure the blade is not contacting theworkpiece before the switch is turned on.11. Wait until the blade attains full speed beforecutting.12. Always switch off and wait for the blades tocome to a complete stop before any adjusting.13. Never stick your finger into the chip chute.Chute may jam when cutting damp wood.Clean out chips with a stick.14. Do not leave the tool running. Operate the toolonly when hand-held.15. Always change both blades or covers on thedrum, otherwise the resulting imbalance willcause vibration and shorten tool life.16. Use only Makita blades specified in thismanual.17. Always use the correct dust mask/respiratorfor the material and application you areworking with.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto safety rules for the subject product.MISUSE or failure to follow the safety rules stated inthis instruction manual may cause serious personalinjury. USD201-2SymbolsThe followings show the symbols used for tool.･ volts･ amperes･ hertz･ alternating current･ no load speed･ Class II Construction･ revolutions or reciprocation per minuteFUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Adjusting depth of cut12010336Depth of cut may be adjusted by simply turning the knobon the front of the tool so that the pointer points thedesired depth of cut.Switch action12010332CAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly andreturns to the "OFF" position when released.• Switch can be locked in "ON" position for ease ofoperator comfort during extended use. Applycaution when locking tool in "ON" position andmaintain firm grasp on tool.To start the tool, simply pull the switch trigger. Releasethe switch trigger to stop.For continuous operation, pull the switch trigger andthen push in the lock button.To stop the tool from the locked position, pull the switchtrigger fully, then release it.1. Switch trigger2. Lock button1. Pointer2. Knob

/ 32

Related manuals for Makita KP0800

Makita KP0800 Instruction Manual

This manual is suitable for:

KP0800

manualsdatabase

Your AI-powered manual search engine