Makita LS0714N Instruction Manual

Also see for LS0714: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

9ENE006-1Intended useThe tool is intended for accurate straight and mitercutting in wood. With appropriate saw blades, aluminumcan also be sawed. ENF002-2Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, and canonly be operated on single-phase AC supply. They aredouble-insulated and can, therefore, also be used fromsockets without earth wire. ENG905-1NoiseThe typical A-weighted noise level determined accordingto EN61029:Sound pressure level (LpA) : 92 dB (A)Sound power level (LWA) : 101 dB (A)Uncertainty (K) : 3 dB (A)Wear ear protectionENG900-1VibrationThe vibration total value (tri-axial vector sum) determinedaccording to EN61029:Vibration emission (ah ) : 2.5 m/s 2 or lessUncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard test methodand may be used for comparing one tool with another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of the powertool can differ from the declared emission valuedepending on the ways in which the tool is used.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH003-15For European countries onlyEC Declaration of ConformityMakita declares that the following Machine(s):Designation of Machine:Slide Compound SawModel No./ Type: LS0714, LS0714F, LS0714FL, LS0714LConforms to the following European Directives:2006/42/ECThey are manufactured in accordance with the followingstandard or standardized documents:EN61029The technical file in accordance with 2006/42/EC isavailable from:Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium30.6.2014000331Yasushi FukayaDirectorMakita, Jan-Baptist Vinkstraat 2, 3070, BelgiumGEA010-1General Power Tool SafetyWarningsWARNING Read all safety warnings and allinstructions. Failure to follow the warnings and instructionsmay result in electric shock, fire and/or serious injury.Save all warnings and instructions forfuture reference. ENB034-10MITER SAW SAFETY WARNINGS1. Keep hands out of path of saw blade. Avoidcontact with any coasting blade. It can stillcause severe injury.2. Check the saw blade carefully for cracks ordeformation before operation.Replace damaged blades immediately.3. Replace the kerf board when worn.4. Use only saw blades specified by themanufacturer which conform to EN847-1.5. Do not use saw blades manufactured fromhigh speed steel.6. Wear eye protection.7. Wear hearing protection to reduce the risk ofhearing loss.8. Wear gloves for handling saw blade (sawblades shall be carried in a holder whereverpracticable) and rough material.9. Connect miter saws to a dust collecting devicewhen sawing.10. Select saw blades in relation to the material tobe cut.11. Do not use the saw to cut other than wood,aluminum or similar materials.12. Always secure all moving portions beforecarrying the tool. When lifting or carrying thetool, do not use the guard as a carrying handle.13. Do not operate saw without guards in place.Check blade guard for proper closing before eachuse. Do not operate saw if blade guard does notmove freely and close instantly. Never clamp ortie the blade guard into the open position.