Makita LS1214 Instruction Manual

Also see for LS1214: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

2ENGLISHSPECIFICATIONSModel LS1214 / LS1214F / LS1214LBlade diameter 305 mmHole diameter European countries: 30 mm, other than European countries: 25.4 mmMax. Miter angle Left 47° , Right 52°Max. Bevel angle Left and Right 45°Max. Cutting capacities (H x W)Bevel angleMiter angle 45° (left) 0° 45° (right)0° *71 mm x 260 mm *120 mm x 270 mm *50 mm x 260 mm66 mm x 305 mm 115 mm x 308 mm 45 mm x 305 mm(left) *71 mm x 155 mm45° (left and right) 66 mm x 170 mm *120 mm x 185 mm *50 mm x 175 mm(right) *71 mm x 175 mm 115 mm x 218 mm 45 mm x 215 mm66 mm x 215 mm52° (right) - *120 mm x 160 mm -115 mm x 185 mm(Note)* mark indicates that a wood facing with the following thickness is used.Miter angle Thickness of wood0° 20 mm45° (left and right) 15 mm52° (right) 15 mmNo load speed (min -1) 3,200Laser Type (LS1214L only) Red Laser 650 nm, 1mW ( Laser Class 2 )Dimensions (L x W x H) LS1214/LS1214F 723 mm x 520 mm x 696 mmLS1214L 723 mm x 520 mm x 718 mmNet weight LS1214 24.4 kg, LS1214F 24.6 kg, LS1214L 25.3 kgSafety class /II• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003END216-4SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.･ Read instruction manual.･ DOUBLE INSULATION･ To avoid injury from flying debris, keepholding the saw head down, aftermaking cuts, until the blade has cometo a complete stop.･ When performing slide cut, first pullcarriage fully and press down handle,then push carriage toward the guidefence.･ Do not place hand or fingers close tothe blade.･ For your safety, remove the chips, smallpieces, etc. from the table top beforeoperation.･ Always set SUB-FENCE to left positionwhen performing left bevel cuts. Failureto do so may cause serious injury tooperator.･ Always remove SUB-FENCE R whenperforming right bevel cuts. Failure todo so may cause serious injury tooperator.･ Never look into the laser beam. Directlaser beam may injure your eyes.