6• Use the reversing switch only after the tool comesto a complete stop. Changing the direction ofrotation before the tool stops may damage the tool.When not operating the tool, always set the reversingswitch lever to the neutral position.Depth adjustment1 AB011813The depth can be adjusted by turning the locator. Turn itin "B" direction for less depth and in "A" direction for moredepth. One full turn of the locator equals 2 mm (1/16")change in depth.13 mm (1/8")011827Adjust the locator so that the distance between the tip ofthe locator and the screw head is approximately 3 mm(1/8") as shown in the figures. Drive a trial screw into yourmaterial or a piece of duplicate material. If the depth isstill not suitable for the screw, continue adjusting until youobtain the proper depth setting.ASSEMBLYCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before carrying outany work on the tool.Installing or removing the bit1011819To remove the bit, pull the locator. Then grasp the bit witha pair of pliers and pull the bit out of the magnetic bitholder. Sometimes, it helps to wiggle the bit with thepliers as you pull.123011820To install the bit, push it firmly into the magnetic bit holder.Then install the locator by pushing it firmly back.Hook1 2 3011821The hook is convenient for temporarily hanging the tool.This can be installed on either side of the tool.To install the hook, insert it into a groove in the toolhousing on either side and then secure it with a screw. Toremove, loosen the screw and then take it out.OPERATIONScrewdriving operation011822Fit the screw on the point of the bit and place the point ofthe screw on the surface of the workpiece to be fastened.Apply pressure to the tool and start it. Withdraw the toolas soon as the clutch cuts in. Then release the switchtrigger.CAUTION:• When fitting the screw onto the point of the bit, becareful not to push in on the screw. If the screw is1. Groove2. Hook3. Screw1. Locator2. Bit3. Magnetic bitholder1. Locator1. Locator1. Locator