Makita MLT100 Instruction Manual

Also see for MLT100: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

7This tool is provided with the sub table (R) on the rightside of the main table. To use the sub table (R), loosentwo screws on the right side counterclockwaise, pull outthe table (R) fully and then tighten the two screws.Sub table (back)12008768To use the sub table (back), loosen the screws on the leftand right hand sides under the table and pull it outbackwards to the desired length. At the desired length,tighten the screw securely.Slide table1009707This tool is provided with the slide table on the left side.The slide table slides back and forth.Hold workpiece firmly with the miter gauge using aclamp on the miter gauge and slide the workpiecetogether with the slide table at the time of cuttingoperation.ASSEMBLYOverview of Table Saw Blade GuardingSystem1234 5009912WARNING:• Always be sure that the tool is switched off andunplugged before carrying out any work on thetool.The saw blade and blade guard are not installed on thetool when it is shipped from the factory.Installing or removing saw bladeWARNING:• Always be sure that the tool is switched off andunplugged before installing or removing the blade.• Use only the Makita socket wrench provided toinstall or remove the blade. Failure to do so mayresult in overtightening or insufficient tightening ofthe hex bolt. This could cause an injury.123009892Remove the table insert on the table. Hold the outerflange with the wrench and loosen the hex nutcounterclockwise with the wrench. Then remove theouter flange.Assemble the inner flange, blade, outer flange and hexnut onto the arbor, making sure that the teeth of theblade are pointing down at the front of the table. Alwaysinstall the hex nut with its recessed side facing the outerflange.1 234006136CAUTION:• Keep the flange surface clean of dirt or otheradhering matter; it could cause blade slippage. Besure that the blade is installed so that the teeth arealigned in the cutting (turning) direction.1. Inner flange2. Outer flange3. Saw blade4. Hex nut1. Wrench2. Hex nut3. Wrench1. Table saw bladeguard assembly2. Antikickback pawls3. Riving knife / spreader4. Riving knife /spreader releaselever location5. Table saw bladeside guards1. Slide table1. Screws2. Sub table (back)

/ 56

Related manuals for Makita MLT100

Makita MLT100 Instruction Manual

This manual is suitable for:

MLT100

manualsdatabase

Your AI-powered manual search engine