15RESHARPENING THE CUTTING TOOLCAUTION: The cutting tools mentioned below must only be resharpened by anauthorized facility. Manual resharpening will result in imbalancesof the cutting tool causing vibrations and damage to the equipment.– cutter blade (star blade (4 teeth), eddy blade (8 teeth))An expert resharpening and balancing service is provided by AuthorizedService Agents.NOTE: To increase the service life of the cutter blade (star blade, eddy blade) itmay be turned over once, until both cutting edges have become blunt.NYLON CUTTING HEADThe nylon cutting head is a dual string trimmer head capable of both automatic and bump & feed mechanisms.The nylon cutting head will automatically feed out the proper length of nylon cord by the changes in centrifugal force caused by increasing ordecreasing RPMS. However, to cut soft grass more efficiently, bump the nylon cutting head against the ground to feed out extra cord asindicated under operation section.Operation– Increase the nylon cutting head speed to approx. 6,000rpm.Low speed (under 4,800rpm) is not suitable, the nylon cord will not feed outproperly at low speed.– The most effective cutting area is shown by the shaded area.If the nylon cord does not feed out automatically proceed as follows:1. Release the throttle lever to run the engine idle and then squeeze the throttlelever fully. Repeat this procedure until the nylon cord feeds out to theproper length.2. If the nylon cord is too short to feed out automatically with the aboveprocedure, bump the knob of the nylon cutting head against the ground tofeed out the nylon cord.3. If the nylon cord does not feed out with procedure 2, rewind/replace thenylon cord by following the procedures described under “Replacing the nyloncord”.Replacing the nylon cord– First, stop the engine.– Press on the housing latches inward to lift off the cover, then remove thespool.– Hook the center of new nylon cord into the notch in the center of the spool,with one end of the cord extending about 80mm (3-1/8") more than the other.Then wind both ends firmly around the spool in the direction of the headrotation (left-hand direction indicated by LH and right-hand direction by RH onthe side of the spool).Most effective cutting areaIdle speed Full speedKnobCover80mm(3-1/8”)PressLatchesSpoolFor left handrotationSpoolPress

Safety instructions

ec declaration of conformity

Technical data

Designation of parts

Assembly of engine and shaft

Mounting of handle

Mounting of protector

Fuels/Refuelling

Correct handling of machine

Idle adjustment

Resharpening the cutting tool

Nylon cutting head

Storage

norme di sicurezza

messa in funzione

Makita RBC2100 Original Instruction Manual

RBC2100

RBC2110