Makita RBC3100 Original Instruction Manual

Also see for RBC3100: Instruction manual

Contents

Makita RBC3100 Original Instruction Manual Manual pdf 10 page image

10CAUTION: Before doing any work on the brush cutter, always switch off the motorand pull the spark plug connector off the spark plug.Always wear protective gloves.CAUTION: Start the brush cutter only after having assembled it completely.- Loosen the two bolts (1) and insert the main pipe (2) into the case clutch (3).- Insert it up to the arrow-mark position. (Refer to the sketch on the right.) If it isdifficult to insert, turn the spline (4) a little and re-insert.- Match the hole (5) of the main pipe (2) with the bolt hole (6) of the case clutch, andtighten the attached bolts (7).- Tighten the two bolts (1) uniformly on the right and left by Allen wrench supplied.How to mount the control cable- Remove the air cleaner cover.- Put the control cable (8) into the adjusting cable (9). Shift the swivel (10) and putthe cable into the swivel. At this time, be careful that the round hole in the swivel isoriented toward the fitting at the inner wire end.- Release the swivel and make sure that the inner wire fitting is placed in the hole.- Mount the air cleaner cover.Connection of the switch cordConnect the switch cords to the two cords from the engine by inserting one into theother.- Fix the cord connector by clamp.ASSEMBLY OF ENGINE AND SHAFTControl cableSwivelRound holeEnd fittingInsertClamp Connectors