Makita RBC411U Instruction Manual

Also see for RBC411: Instruction manual Instruction manual

Contents

Makita RBC411U Instruction Manual Manual pdf 14 page image

(4)(3)(2)(1)(3)(1)(2)StartingMove at least 3m (10ft) away from the place of refuelling. Place the brushcutter on a clean piece of ground taking care that the cutting tool doesnot come into contact with the ground or any other objects.First place the machine on the ground.–Open the fuel valve. The valve opens when the lever (5) is at right angles to the–ground (6). The valve closes when the lever is parallel with the ground (7).Move the choke lever (8) to the top position (– ).Firmly hold the clutch case by your left hand, as illustrated.–Slowly pull the starter grip until resistance is felt and continue with a smart pull.–Do not pull out the starter rope to its full extent and do not allow the starter handle–to be retracted without control, but ensure that it is retracted slowly.Repeat the starting operation until initial ignitions are heard.–Depress the choke lever (– ) and pull the starter rope again until the enginestarts.As soon as the engine starts, immediately tap and release the throttle, thus–releasing the half-throttle lock so that the engine can run in idle.Run the engine for approximately one minute at a moderate speed before–applying full throttle.Caution during operation:If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min -1 or more. Never operate the engine at ahigher speed than required and at an approximate speed of 6,000 - 8,000 min -1 .Cold startFor RBC411•Push the I-O switch (1) in the direction shown by the arrow.–Grasp the handle (hand pressure activates the safety lock-off lever (2)).–Press the throttle lever (3) and hold it down.–Press the lock button (4) and release the control lever, and then release the lock–button (the lock button holds the throttle lever in the start-up position).PUTTING INTO OPERATIONRBC411RBC411UFor RBC411U•Grasp the handle (hand pressure activates the safety lock-off lever (1)).–Press the throttle lever (2) and hold it down.–Push the I-O switch (3) to START.–Observe the applicable accident prevention regulations!14