Makita RBC413U Instruction Manual

Also see for RBC413U: Instruction manual Technical information

Contents

Makita RBC413U Instruction Manual Manual pdf 9 page image

(2)(1)CAUTION: Before doing any work on the brushcutter, always switch off the motorand pull the spark plug connector off the spark plug.Always wear protective gloves.CAUTION: Start the brushcutter only after having assembled it completely.After checking the parts, fasten the drive shaft to the engine with four bolts–M6 x 20 (1). At this time, fasten also the earth terminal (2) of the stop cord to theengine.CAUTION: Before doing any work on the brushcutter, always stop the engine andpull the spark plug connector off the spark plug. Always wear protectivegloves!CAUTION: Start the brushcutter only after having assembled it completely.For model RBC413UPlace the handle with the throttle lever on the handle holder on the right side (to–be held by the right hand) and the other on the left side.Fit the handle edge to the handle holder groove, and provisionally fix the upper–side (1) of the handle holder by four bolts M5 x 25 (2).Adjust the handle to an angle easy to manipulate, and tighten the bolt (2)–uniformly on the right and left sides.ASSEMBLY OF ENGINE AND SHAFTMOUNTING OF HANDLE(1)(2)(3)(4)(5)For model RBC414ULoosen knob (1).–Place handle (4) between handle clamp (2) and handle holder (3).–Adjust handle (4) to an angle that provides a comfortable working position and–then secure by firmly hand-tightening knob (1).CAUTION: Do not forget to mount spring (5).Engine9