2ENGLISHSPECIFICATIONSModel RP0900Collet chuck capacity 8 mm or 3/8"Plunge capacity 0 - 35 mmNo load speed (min -1) 27,000Overall height 217 mmNet weight 2.7 kgSafety class /II• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.• Note: Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003END201-4SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.・ Read instruction manual.・ DOUBLE INSULATION・ Only for EU countriesDo not dispose of electric equipmenttogether with household waste material!In observance of European Directive2002/96/EC on waste electric andelectronic equipment and itsimplementation in accordance withnational law, electric equipment thathave reached the end of their life mustbe collected separately and returned toan environmentally compatiblerecycling facility. ENE010-1Intended useThe tool is intended for flush trimming and profiling ofwood, plastic and similar materials. ENF002-1Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated in accordance with EuropeanStandard and can, therefore, also be used from socketswithout earth wire. ENG102-1For European countries onlyNoiseThe typical A-weighted noise level determined accordingto EN60745-2-17:Sound pressure level (LpA) : 89 dB(A)Sound power level (LWA) : 100 dB(A)Uncertainty (K) : 3 dB(A)Wear ear protectionENG223-1VibrationThe vibration total value (tri-axial vector sum)determined according to EN60745-2-17:Work mode : cuttig grooves in MDFVibration emission (ah ) : 4.0 m/s 2Uncertainty (K) : 1.5 m/s 2ENH101-9EC-DECLARATION OF CONFORMITYModel; RP0900We declare under our sole responsibility that thisproduct is in compliance with the following standards ofstandardized documents;EN60745, EN55014, EN61000 in accordance withCouncil Directives, 2004/108/EC, 98/37/EC.CE2008000230Tomoyasu KatoDirectorResponsible Manufacturer:Makita Corporation3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPANAuthorized Representative in Europe:Makita International Europe Ltd.Michigan Drive, Tongwell, Milton Keynes, Bucks MK158JD, ENGLAND GEA005-2General Power Tool SafetyWarningsWARNING Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in electric shock, fire and/orserious injury.