8Dust nozzle set (Accessory)12009754Use the dust nozzle for dust extraction. Install the dustnozzle on the tool base using the thumb screw so thatprotrusion on the dust nozzle fit to the notch in the toolbase.Then connect a vacuum cleaner to the dust nozzle.Fig.15MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.• Never use gasoline, benzine, thinner, alcohol orthe like. Discoloration, deformation or cracks mayresult.To maintain product SAFETY and RELIABILITY, repairs,any other maintenance or adjustment should beperformed by Makita Authorized Service Centers,always using Makita replacement parts.OPTIONAL ACCESSORIESCAUTION:• These accessories or attachments arerecommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory orattachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.• Straight & groove forming bits• Edge forming bits• Laminate trimming bits• Straight guide• Templet guide 25• Templet guides• Templet guide adapter• Lock nut• Collet cone 3/8", 1/4"• Collet cone 6 mm, 8 mm• Wrench 13• Wrench 22• Dust nozzle setRouter bitsStraight bitFig.16mmD A L 1 L 261/4"8 8 60 2561/4"61/4"6 50 188 50 1820 50 15009802"U"Grooving bitFig.17mmD A L 1 L 2 R6 6 50 18 3009803"V"Grooving bitFig.1890mmD A L 1 L 21/4" 20 50 15009804Drill point flush trimming bitFig.19D86A68L 16060L 21820L 32835mm0098061. Dust nozzle2. Thumb screw