Makita RP0910 Instruction Manual

Also see for RP0910: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita RP0910 Instruction Manual Manual pdf 2 page image

2ENGLISH (Original instructions)SPECIFICATIONSModel RP0910 RP1110CCollet chuck capacity 8 mm or 1/4" 8 mm or 1/4"Plunge capacity 0 - 57 mm 0 - 57 mmNo load speed (min -1) 27,000 8,000 - 24,000Overall height 260 mm 260 mmNet weight 3.3 kg 3.4 kgSafety class /II /II• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003END201-5SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.읭 Read instruction manual.읭 DOUBLE INSULATION읭 Only for EU countriesDo not dispose of electric equipmenttogether with household waste material!In observance of European Directive2002/96/EC on waste electric andelectronic equipment and itsimplementation in accordance withnational law, electric equipment thathave reached the end of their life mustbe collected separately and returned toan environmentally compatiblerecycling facility. ENE010-1Intended useThe tool is intended for flush trimming and profiling ofwood, plastic and similar materials. ENF002-2Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated and can, therefore, also be usedfrom sockets without earth wire. ENG905-1NoiseThe typical A-weighted noise level determined accordingto EN60745:Model RP0910Sound pressure level (LpA) : 83 dB(A)Sound power level (LWA) : 94 dB(A)Uncertainty (K) : 3 dB(A)Model RP1110CSound pressure level (LpA) : 81 dB(A)Sound power level (LWA) : 92 dB(A)Uncertainty (K) : 3 dB(A)Wear ear protectionENG900-1VibrationThe vibration total value (tri-axial vector sum)determined according to EN60745:Model RP0910Work mode : cuttig grooves in MDFVibration emission (ah ) : 8.0 m/s 2Uncertainty (K) : 1.5 m/s 2Model RP1110CWork mode : cuttig grooves in MDFVibration emission (ah ) : 5.0 m/s 2Uncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).