Makita RP1800 Instruction Manual

Also see for RP1800: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita RP1800 Instruction Manual Manual pdf 12 page image

12Fig.27Fig.28Fig.29At this time, apply some grease or lubricating oil to theinside of the screw hole in the tool base and the threadedpart in the motor bracket.Fig.30Fig.312. Adjusting the depth of cut• A small amount of depth of cut can be obtained byturning this screw with a screwdriver from abovethe table. (1.0 mm per a full turn)• Turning it clockwise makes the depth of cut greaterand turning it counterclockwise smaller.Fig.32MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.• Never use gasoline, benzine, thinner, alcohol or thelike. Discoloration, deformation or cracks mayresult.Replacing carbon brushesFig.33Remove and check the carbon brushes regularly.Replace when they wear down to the limit mark. Keepthe carbon brushes clean and free to slip in the holders.Both carbon brushes should be replaced at the sametime. Use only identical carbon brushes.Use a screwdriver to remove the brush holder caps. Takeout the worn carbon brushes, insert the new ones andsecure the brush holder caps.Fig.34After replacing brushes, plug in the tool and break inbrushes by running tool with no load for about 10 minutes.Then check the tool while running and electric brakeoperation when releasing the switch trigger. If electricbrake is not working well, ask your local Makita servicecenter for repair.To maintain product SAFETY and RELIABILITY, repairs,any other maintenance or adjustment should beperformed by Makita Authorized Service Centers, alwaysusing Makita replacement parts.OPTIONAL ACCESSORIESCAUTION:• These accessories or attachments arerecommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory orattachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.• Straight & groove forming bits• Edge forming bits• Laminate trimming bits• Straight guide• Trimmer guide• Guide holder• Templet guides• Templet guide adapter• Lock nut• Collet cone 12 mm, 1/2"• Collet sleeve 6 mm, 8 mm, 10 mm• Collet sleeve 3/8", 1/4"• Wrench 24• Vacuum head setRouter bitsStraight bitFig.35mmD A L 1 L 261/4"8 8 60 2561/4"61/4" 6 50 188 50 1820 50 151/2"121/2"1212 60 3010 60 25006452"U"Grooving bitFig.36mmD A L 1 L 2 R6 6 50 18 3006453"V"Grooving bitFig.37mmD A L 1 L 21/4" 20 50 15 90006454