Makita TW007G Instruction Manual

Also see for TW007G: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

10 ENGLISHChanging the application modeThis tool employs several easy-to-use application modes for driving bolts with good control.The type of the application mode changes every time you press the button .You can change the application mode within approximately one minute after releasing the switch trigger.NOTE: You can extend the time to change the application mode approximately one minute if you press the but-ton or .► Fig.8Application mode(Assist type displayed on panel)Feature PurposeBolt mode ClockwiseThis mode helps to repeat screwdriving continuously withequal torque. This mode also helps to reduce the risk ofbreakage of bolts/nuts due to overtightening.CounterclockwiseThis mode helps to prevent a bolt from falling off. Whenloosening a bolt with the tool driving in counterclockwiserotation, the tool automatically stops or slows down afterthe bolt/nut gets enough loosened.NOTE:The timing to stop the driving varies depending on thetype of the bolt/nut and material to be driven. Make atest driving before using this mode.ClockwisePreventing overtightening ofbolts.CounterclockwiseLoosening bolts.Bolt mode (1) ClockwiseThe tool stops automatically as soon as it has startedimpact blows.CounterclockwiseThe impact force is 4. The tool stops automatically as soonas it has stopped impact blows.–Bolt mode (2) ClockwiseThe tool stops automatically approximately 0.5 secondlater from the moment that the tool has started impactblows.CounterclockwiseThe impact force is 4. The tool stops automatically approx-imately 0.2 second later from the moment that the tool hasstopped impact blows.–Bolt mode (3) ClockwiseThe tool stops automatically approximately 1 second laterfrom the moment that the tool has started impact blows.CounterclockwiseThe tool slows down the rotation after it has stoppedimpact blows.–: The lamp is on.NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button .NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of theapplication mode can be checked by pulling the switch trigger to the extent that the tool does not operate.Full speed mode► Fig.9: 1. Button 2. LampWhen full speed mode is turned on, the tool speedbecomes fastest even if you do not pull the switch trig-ger fully. When full speed mode is turned off, the toolspeed increases as you increase the pressure on theswitch trigger.To turn on full speed mode, press and hold the but-ton . To turn off full speed mode, press and hold thebutton again.The lamp turns on while full speed mode is on.NOTE: Full speed mode continues even after switch-ing the impact force mode/auto stop mode.Electronic functionElectric brakeThis tool is equipped with an electric brake. If the toolconsistently fails to quickly cease to function after theswitch trigger is released, have the tool serviced at aMakita service center.