Makita TW0200 Instruction Manual

Also see for TW0200: Instruction manual Parts Breakdown Instruction manual Instruction manual Parts Breakdown

Contents

specifications

3ENGLISH (Original instructions)Explanation of general view1-1. Switch trigger2-1. Reversing switch lever3-1. Socket3-2. Anvil4-1. Socket4-2. O-ring4-3. Pin5-1. Hook7-1. Limit mark8-1. Brush holder cap8-2. ScrewdriverSPECIFICATIONSModel TW0200Standard bolt M10 - M16Capacities High tensile bolt 10 mm - 12 mmSquare drive 12.7 mmNo load speed (min -1) 0-2,200Impacts per minute 0-2,200Max. fastening torque 200 N.mOverall length 251 mmNet weight 2.2 kgSafety class /II• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003ENE036-1Intended useThe tool is intended for fastening bolts and nuts. ENF002-1Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated in accordance with EuropeanStandard and can, therefore, also be used from socketswithout earth wire. ENG102-3NoiseThe typical A-weighted noise level determined accordingto EN60745:Sound pressure level (LpA) : 93 dB(A)Sound power level (LWA) : 104 dB(A)Uncertainty (K) : 3 dB(A)Wear ear protection ENG205-2VibrationThe vibration total value (tri-axial vector sum)determined according to EN60745:Work mode : impact tightening of fasteners of themaximum capacity of the toolVibration emission (ah ) : 8.5 m/s 2Uncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH101-13For European countries onlyEC Declaration of ConformityWe Makita Corporation as the responsiblemanufacturer declare that the following Makitamachine(s):Designation of Machine:Impact WrenchModel No./ Type: TW0200are of series production andConforms to the following European Directives:98/37/EC until 28th December 2009 and then with2006/42/EC from 29th December 2009