Makita UH4570 Instruction Manual

Also see for UH5570: Catalog Instruction manual Instruction manual Instruction manual Instruction manual

Contents

8009286Attaching the chip receiver (accessory) on the tool whentrimming the hedge straight can avoid cut off leaves'being thrown away.009287To cut a hedge side evenly, it helps to cut from thebottom upwards.009288Trim boxwood or rhododendron from the base towardthe top for a nice appearance and good job.009289Installing or removing chip receiver(accessory)CAUTION:• Always be sure that the tool is switched off andunplugged before installing or removing chipreceiver.NOTE:• When replacing the chip receiver, always weargloves so that hands and face does not directlycontact the blade. Failure to do so may causepersonal injury.• Always be sure to remove the blade cover beforeinstalling the chip receiver.• The chip receiver receives cut-off leaves andalleviates collecting thrown-away leaves. This canbe installed on either side of the tool.1 234009290Press the chip receiver on the shear blades so that itsslits overlap with the nuts on the shear blades. At thistime, make sure that the chip receiver does not contactbranch catcher at the top of the shear blades.12009291At this time, the chip receiver needs to be installed sothat its hooks fit into grooves in the shear blade unit.123009292To remove the chip receiver, press its lever on both sidesso that the hooks are unlocked.1. Hooks2. Fit the hooksinto groove3. Grooves1. Nut2. Branch catcher1. Press2. Chip receiver3. Nut4. Shear blade