Makita XEC01 Series Instruction Manual

10 ENGLISH12345 5► 1. Hex bolt 2. Outer flange (black) 3. Abrasive cut-off wheel / diamond wheel 4. Inner flange (silver)5. Arrow (rotation direction of the wheel)To install the wheel, follow the removal procedure inreverse.BE SURE TO TIGHTEN THE HEX BOLT SECURELY.CAUTION: Always install the wheel so thatthe arrow on it points in the same direction asthe arrow on the wheel guard. Otherwise the wheelrotates in reverse, it may cause personal injury.CAUTION: Only use the wheel that aremarked with a speed equal or higher than thespeed marked on the tool.NOTE: If an inner flange is removed by chance,install the inner flange so that taller protrusion facesthe tool side as shown in the figure.12 345► 1. Hex bolt 2. Outer flange (black) 3. Abrasive cut-off wheel / diamond wheel 4. Inner flange (silver)5. Protrusion (taller)Connecting to water supply1. Prepare a water hose.2. Remove the nut on the coupling sleeve and passthe water hose through the nut. Insert the end of thehose into the coupling sleeve and then tighten the nut.123► 1. Water hose 2. Nut of the coupling sleeve3. Coupling sleeve3. Connect the water hose to the water supply.When connecting to a water faucet, use a suitable fittingsuch as hose band or water tap joint.1 23► 1. Hose band 2. Water tap joint 3. Water hoseNOTE: The fitting depends on the shape of the faucetto which you connect. Prepare a suitable commercial-ly-bought fitting.NOTE: If you use a water tap joint, prepare anothercoupling sleeve and attach it to the other end of thehose.NOTE: When using a water pump, follow the instruc-tions of your water pump to connect the water hose.