Makita XMU02 Instruction Manual

8123012541Overlap the oval hole in the upper blade with that in thelower one. Move the shear blades so that the hole in thebase plate of shear blades are positioned in the center ofthese overlapped oval holes.012542Turn the shear blades upside down and install it so thatthe pins on the tool fit in the hole in the shear blades.Make sure that the shear blades are set in place securelyas far as they reach the base plate.12012534Place the undercover so that the symbol on theundercover is aligned with the symbol on the lockinglever.012543Press the undercover down and turn the undercoverclockwise while pressing it down until the symbol onthe label is aligned with the symbol on the lockinglever (the undercover is completely locked.).12012544At this time, make sure that the locking lever fits in thegroove in the undercover.Remove the blade cover and then turn on the tool tocheck it for proper movement.NOTE:• When the shear blades do not operate properly,there is a poor fit between the blades and crank.Redo from the beginning.OPERATIONWARNING:• Keep hands away from blades.CAUTION:• Smear the blade before and once per hour duringoperation using machine oil or the like.• Avoid operating the tool under the scorchingsunlight as much as practicable. When operatingthe tool, be careful of your physical conditions.• Hold the tool with one hand. Do not hold the frontbulge of the tool as a grip.012530Turn the tool on after adjusting the shearing height andhold it so that the foot of the tool rest on the ground.Then gently move the tool forward into the area to becut.1. Base plate2. Hole in the baseplate of shearblades3. Oval holes thatare overlapped1. Undercover2. Locking lever1. Groove in theundercover2. Locking lever