Makita XSC04 Instruction Manual

9 ENGLISHLighting the lampCAUTION: Do not look in the light or see thesource of light directly.To turn on the lamp without running the tool, pull theswitch trigger without pressing the lock-off button.To turn on the lamp with the tool running, press and holdthe lock-off button and pull the switch trigger.The lamp goes out 10 seconds after releasing the switch trigger.1► 1. LampNOTE: Use a dry cloth to wipe the dirt off the lens ofthe lamp. Be careful not to scratch the lens of lamp, orit may lower the illumination.Dust boxCAUTION: Do not touch saw dust and thedust box with bare hands immediately after theoperation. They may be extremely hot and couldburn your skin.CAUTION: Do not cut the material on whichthinner, gasoline, grease, or other chemicals areapplied. The saw dust of such materials can damagethe dust box and result in breakage which can causepersonal injury.CAUTION: Wear eye protection or gogglewhen emptying the dust box.Saw dust is collected into the dust box. Periodicallydump the saw dust in the dust box before it gets full.Push the lever on the dust box to open the lid. Dumpthe saw dust while the rear of the tool faces downward.12► 1. Lid 2. LeverHookOptional accessoryCAUTION: Always remove the battery whenhanging the tool with the hook.CAUTION: Never hook the tool at high locations oron the surfaces where the tool may lose the balance and fall.CAUTION: Do not pull the tool downwardwhen it is hooked.CAUTION: Always fold the hook when operat-ing the tool.The hook is convenient for hanging the tool temporarily.Attach the hook with the screws as illustrated.12► 1. Hook 2. Screw