Makita XVJ05 Instruction Manual

7 ENGLISHTo change the cutting action, turn the cutting actionchanging lever to the desired cutting action position.Refer to the table to select the appropriate cuttingaction.Position Cutting action Applications0 Straight line cuttingactionFor cutting mildsteel, stainlesssteel and plastics.For clean cuts inwood and plywood.I Small orbitalcutting actionFor cutting mildsteel, aluminumand hard wood.II Medium orbitalcutting actionFor cutting woodand plywood.For fast cutting inaluminum and mildsteel.III Large orbitalcutting actionFor fast cutting inwood and plywood.Lighting up the front lampCAUTION: Do not look in the light or see thesource of light directly.To turn on the lamp, press the lock/unlock button. Toturn off the lamp, press the lock/unlock button again.12Fig.4► 1. Lamp 2. Lock/unlock buttonNOTICE: When the tool is overheated, the lampblinks. Cool down the tool fully before operatingthe tool again.NOTE: Use a dry cloth to wipe the dirt off the lens ofthe lamp. Be careful not to scratch the lens of lamp, orit may lower the illumination.Switch actionTo turn on the tool, press the lock/unlock button. Thetool turns into the standby mode. To start the tool, pressthe start/stop button in the standby mode. To stop thetool, press the start/stop button again. The tool turnsinto the standby mode. To turn off the tool, press thelock/unlock button in the standby mode.12Fig.5► 1. Lock/unlock button 2. Start/stop buttonNOTE: If the tool is left for 10 seconds without anyoperation in the standby mode, the tool automaticallyturns off and the lamp goes off.NOTE: You can also stop and turn off the tool bypressing the lock/unlock button while the tool isoperating.To decreases the brightness of the lamp, press and holdthe lock/unlock button when turning into the standbymode. About 1 second after you start pressing the lock/unlock button, the brightness of the lamp will start todecrease, so release the lock/unlock button when youreach the desired brightness. It turns the tool into thestandby mode, too. About 3 seconds after you startpressing the lock/unlock button, the brightness of thelamp will be minimized and the brightness will notchange after that.NOTE: The brightness of the lamp cannot beadjusted while the tool is in standby mode. To adjustthe brightness of the lamp, turn off the tool.NOTE: There is no memory function for the bright-ness of the lamp. If you turn the lamp off and then turnit on, the brightness of the lamp will be maximizedeach time.