Malm Fireplaces carousel Assembly And Installation Instructions Manual

Also see for Gas Carousel: Assembly and installation instructions

Contents

Malm Fireplaces carousel Assembly And Installation Instructions Manual Manual pdf 2 page image

GENERAL INFORMATIONThis appliance has been tested in accordance with National Safety Standards and has been certifi edby Lab Test for installation and operation as described in this manual.Please read all the instructions before beginning your installation. Check with your local buildingcode agency to ensure compliance with local codes. In the absence of local codes the installationmust comply with National Fuel Gas Code ANSI Z223.1. In Canada, current CAN/CGA-B149.1 andB149.2 installation codes.Installation and repair should be done by a qualified service person. The appliance should beinspected before use and at least annually by a qualifi ed service person. More frequent cleaningmay be required due to excessive lint from carpeting, bedding material, etc. It is imperative thatcontrol compartments, burners and circulating air passageways of the appliance must kept clean.Gas Carousel Page - 2Unpack all parts from cartons carefully inspecting all parts. If any parts are damaged or missing,contact shipper or dealer immediately.Do not install this appliance using damaged parts.GAS SUPPLYFor use with natural gas or propane gas, depending on which option you have ordered. The minimuminlet gas supply pressure for the purpose of input adjustment:Natural = Minimum 5.0" Water Column (1.4 kPa) Maximum 10.5" Water Column (2.6 kPa)Propane = Minimum 11" Water Column (2.75 kPa) Maximum 13" Water Column (3.25 kPa)a. The supply system should include a manual shut-off valve and union in the line, so that the heatercan be disconnected for servicing.b. The appliance and its individual shut-off valve must be disconnected from the gas supply pipingsystem during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa).c. The appliance must be isolated from the gas supply piping system by closing its individual manualshut-off valve during any pressure testing of the gas supply piping system at test pressures equalto or less than 1/2 psig (3.5 kPa).d. A 1/8 inch N.P.T. plugged tapping is provided, for test gauge connection, on the elbow adjacentto the gas control valve.Due to high temperatures, the appliance should be located out of traffic and away from furnitureand draperies.Gas Carousel 4/08/15