Mamiya 645 AFD II Instructions Manual

Also see for 645 AFD II: User manual

Contents

Mamiya 645 AFD II Instructions Manual Manual pdf 51 page image

101 102Kodak Professional1 2 0EKTACHROMEColor Reversal FilmUsing a TripodElectronic Shutter Release ContactThe Memo Clip on the Back Cover accepts thebox top of the film carton and can also be usedfor other reminders.Memo ClipWhen You Think Something Might Be “Faulty”When using a tripod with 3/8 inch screw thread(instead of 1/4 inch screw thread) remove thesmall screw from the tripod screw hole onthe bottom of the body using a plus screwdriver,then use a coin to remove the tripod screwadapter bushing .This is the socket for connecting a Mamiyaelectromagnetic cable release (sold separately)helpful when taking photos with the mirror up,with long exposures or with slow shutterspeeds.#804821 1 m (3’)#804822 5 m (15’)Tripod/Electronic Shutter Release Contact/Memo ClipIn the conditions below or when the LCDs display the items listed inpages 103 and 104, they are not necessarily faults. Check the camerawhile referring the descriptions below.- Unable to release the shutterCheck to see if the batteries are installed. Check to see if the batteries are dead.Check to see if the power is on (the shutter release selector lever should be set to“S” or “C” position).Check to see if the dark slide has been removed.Check to see if the film back is set to the correct ISO sensitivity (ISO indicatorblinks).Check to see if the camera is advancing the film.Check to see if the rear door is open for shutter release tests without film.- The viewfinder does not show LCD read-outs.Check to see if the batteries are installed. Check to see if the batteries are dead.Check to see if the power is on (the shutter release selector lever is other than in the“L” position).Check to see if the magazine is installed.If the camera has not operated for longer than 15 seconds, the viewfinder LCD read-outs will automatically disappear.- The dark slide cannot be pulled outCheck to see if the batteries are installed. Check to see if the batteries are dead.The magazine is not mounted onto the camera.- Film cannot be wound.Check to see if the batteries are dead.The film still has some remaining frames.Check to see if there is film loaded into the camera.Check to see it the camera is in multiple exposure mode.This camera employs a microcomputer. It is possible that the camera may mal-function when exposed to static electricity or the like. In this case, turn OFF thecamera power and then remove the batteries. Reinstall the batteries, then turnthe power on. If the camera does not function properly after these steps, contactour sales office or service center.