Manitowoc Q130 Installation, Use & Care Manual

Also see for Q210 series: Replacement manual Installation, use & care manual Technician's handbook Installation and service manual Installation, use & care manual

Contents

Manitowoc Q130 Installation, Use & Care Manual Manual pdf 9 page image

Section 2 Installation InstructionsPart Number 040001358 05/10 9Before Starting the Ice MachineAll Manitowoc ice machines are factory-operated and adjusted before shipment. Normally, new installations do notrequire any adjustment.To ensure proper operation, follow the Operational Checks in Section 3 of this manual. Starting the ice machine andcompleting the Operational Checks are the responsibilities of the owner/operator.Adjustments and maintenance procedures outlined in this manual are not covered by the warranty.Installation Checklist! WarningPERSONAL INJURY POTENTIALDo not operate equipment that has been misused,abused, neglected, damaged, or altered/modifiedfrom that of original manufactured specifications.Is the ice machine level?Has all of the internal packing been removed?Have all of the electrical and water connectionsbeen made?Has the supply voltage been tested andchecked against the rating on the nameplate?Is there proper clearance around the icemachine for air circulation?Is the ice machine grounded and polaritycorrect?Has the ice machine been installed whereambient temperatures will remain in the rangeof 40° – 110°F (4° – 43°C)?Has the ice machine been installed where theincoming water temperature will remain in therange of 40° – 90°F (4° – 32°C)?Is there a separate drain for the water-cooledcondenser?Is there a separate drain for the bin?Are the ice machine and bin drains vented?Are all electrical leads free from contact withrefrigeration lines and moving equipment?Has the owner/operator been instructedregarding maintenance and the use ofManitowoc Cleaner and Sanitizer?Has the owner/operator completed the warrantyregistration card?Has the ice machine and bin been sanitized?Is the toggle switch set to ice? (The toggleswitch is located directly behind the front panel).Is the ice thickness control set correctly? (Referto Operational Checks to check/set the correctice bridge thickness).Is the float valve in the OPEN position?