Manitowoc S1800M Installation Use And Care Manual

Section 4 MaintenancePart Number 80-1633-3 4-5REMOVAL OF PARTS FOR CLEANING/SANITIZING1. Turn off the electrical and water supply to the icemachine (and dispenser when applicable).2. Remove all ice from the bin.3. Remove the water curtain and the components youwant to clean or sanitize. See the following pages forremoval procedures for these parts.4. Soak the removed part(s) in a properly mixedsolution.5. Use a soft-bristle brush or sponge (NOT a wirebrush) to carefully clean the parts.6. Use the sanitizing solution and a sponge or cloth tosanitize (wipe) the interior of the ice machine andthe entire inside of the bin/dispenser.7. Thoroughly rinse all of the parts and surfaces withclear water.8. Install the removed parts.NOTE: Incomplete rinsing of the ice thickness probe orwater level probe may leave a residue. This could causethe ice machine to malfunction. For best results, brush orwipe the probes off while rinsing it. Thoroughly dry theprobes before installing them.9. Turn on the water and electrical supply.! WarningDisconnect electric power to the ice machine (anddispenser if applicable) at the electric switch boxbefore proceeding.! WarningWear rubber gloves and safety goggles (and/or faceshield) when handling Ice Machine Cleaner orSanitizer.Solution Type Water Mixed WithCleaner 1 gal. (4 l) 16 oz (500 ml) cleanerSanitizer 4 gal. (15 l) 3 oz (90 ml) sanitizer! CautionDo not mix Cleaner and Sanitizer solutions together.It is a violation of Federal law to use these solutionsin a manner inconsistent with their labeling.! CautionDo not immerse the water pump motor in thecleaning or sanitizing solution.