Manley CONTROL MASTER PREAMPLIFIER Owner's Manual

Contents

Manley CONTROL MASTER PREAMPLIFIER Owner's Manual Manual pdf 4 page image

MAINS CONNECTIONSYour preamplifier has been factory set to the correct mains voltage for your country. Thevoltage setting is marked on the serial badge, located on the rear panel. Check that this com-plies with your local supply.Export units for certain markets have a moulded mains plug fitted to comply with local require-ments. If your unit does not have a plug fitted the coloured wires should be connected to theappropriate plug terminals in accordance with the following code.GREEN/YELLOW EARTH terminalBLUE NEUTRAL terminalBROWN LIVE terminalAs the colours of the wires in the mains lead may not correspond with the coloured markingidentifying the terminals in your plug proceed as follows;The wire which is coloured GREEN/YELLOW must be connected to the terminal in the plugwhich is marked by the letter E or by the safety earth symbol or coloured GREEN or GREENand YELLOW.The wire which is coloured BLUE must be connected to the terminal in the plug which ismarked by the letter N or coloured BLACK.The wire which is coloured BROWN must be connected to the terminal in the plug which ismarked by the letter L or coloured RED.DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER CON-NECTIONS HAVE BEEN MADE.