MAINS CONNECTIONSYour unit has been factory set to the correct mains voltage for your country. The voltage setting ismarked on the serial badge, located on the rear panel. Check that this complies with your localsupply.Export units for certain markets have a moulded mains plug fitted to comply with local requirements.If your unit does not have a plug fitted the coloured wires should be connected to the appropriate plugterminals in accordance with the following code.GREEN/YELLOW EARTH terminalBLUE NEUTRAL terminalBROWN LIVE terminalAs the colours of the wires in the mains lead may not correspond with the coloured marking identifyingthe terminals in your plug proceed as follows;The wire which is coloured GREEN/YELLOW must be connected to the terminal in the plug which ismarked by the letter E or by the safety earth symbol or coloured GREEN or GREEN and YELLOW.The wire which is coloured BLUE must be connected to the terminal in the plug which is marked bythe letter N or coloured BLACK.The wire which is coloured BROWN must be connected to the terminal in the plug which is marked bythe letter L or coloured RED.DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER CONNEC-TIONS HAVE BEEN MADE.