Manley STUDIO STANDARD 350 WATT MONOBLOCK AMPLIFIER Owner's Manual

Contents

Manley STUDIO STANDARD 350 WATT MONOBLOCK AMPLIFIER Owner's Manual Manual pdf 4 page image

MAINS CONNECTIONSYour amplifier has been factory set to the correct mains voltage for your country. The voltage settingis marked on the serial badge, located on the rear panel. Check that this complies with your localsupply.Export units for certain markets have a moulded mains plug fitted to comply with local requirements.If your unit does not have a plug fitted the coloured wires should be connected to the appropriate plugterminals in accordance with the following code.GREEN/YELLOW EARTH terminalBLUE NEUTRAL terminalBROWN LIVE terminalAs the colours of the wires in the mains lead may not correspond with the coloured marking identifyingthe terminals in your plug proceed as follows;The wire which is coloured GREEN/YELLOW must be connected to the terminal in the plug which ismarked by the letter E or by the safety earth symbol or coloured GREEN or GREEN and YELLOW.The wire which is coloured BLUE must be connected to the terminal in the plug which is marked bythe letter N or coloured BLACK.The wire which is coloured BROWN must be connected to the terminal in the plug which is marked bythe letter L or coloured RED.DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER CONNEC-TIONS HAVE BEEN MADE.The Manley Laboratories Studio Reference 350 watt monoblocks requires a significant amount of ACcurrent to operate properly. For best operation, plug the amplifier directly into the wall outlet, avoidingextension cords and other devices which restrict the current supply to amplifier. If extension cables arerequired, be certain that they are high quality, heavy duty (14-12 guage) cables.