Manley Stingray II Owner's Manual

Contents

Manley Stingray II Owner's Manual Manual pdf 19 page image

SPECIFICATIONS- 3 x RCA Line Inputs, 1 x 1/8” Line Input (front panel)- TRIODE - UL Switching- RECORDING OUT- SUBWOOFER OUT- TAPE LOOP (Insert) with Bypass switch- Logic controlled Volume and Balance functions- All-Vacuum Tube Lo-feedback Stereo Integrated Design- Output Tubes: 8 x EL84 - Ships with Russian NOS EL84M (aka 6Pi14Pi-EB)- Driver Tubes: 2 x 6414 - Ships with GE or RAYTHEON JAN NOS USA or 6414W- Input Tubes: 2 x 12AT7EH - Ships with: 12AT7EH large plate Electro-Harmonix Russian- Maximum Output Power UL mode: 32 Watts x 2 channels 1.5% THD @ 1kHz into 5 ohms- Maximum Output Power TRIODE mode: 18 Watts x 2 channels 1.5% THD @ 1kHz into 5 ohms- Frequency Response: 15 Hz - 58 kHz, -1dB- Gain: 35 dB at max Volume- Volume Control Range: 102 dB (1dB per step when turned slowly)- Input Sensitivity UL Full Power: 210 mV in = 32 watts out into 5 ohms with volume control at maximum- Input Sensitivity Triode: 41mV in = 1W into 5 ohms with volume control at 20dB gain setting- Input Sensitivity UL: 35mV in = 1W into 5 ohms with volume control at 20dB gain setting- S/N Ratio: typically 72 dB A-WGT, 20Hz-20KHz, 1W output, 20dB gain, Source Z = shorted input- THD+N Ratio: typically 64 db at 1W output, Bandwidth 22Hz-22Khz, Source = 1Khz Sine wave- Input Impedance: 12 Kohm nominal- Optimum Speaker Load: 5 ohms- Actual Output Impedance at 20Hz: 2.36 ohmsat 1KHz: 2 ohmsat 20KHz: 1.83 ohms- Output Z (Headphone Output): 53 ohms- Damping Factor: 2.4- Scratch Factor: Use pennies under pointed feet to avoid marring cabinetry. Try quarters if you are in upper tax brackets.The bargain performer would be nickels. Paper currency does not function as well. Euro coins work1.54 times better.- Remote Control Type: RF (radio frequency) and IR (infrared), user selectable (IR carrier frequency: 38kHz)- Volume Control: Cirrus Digital Level Control System, controlled by Grayhill Rotary Encoders- Power Consumption: 6W- Power Consumption Idle: 198W- Maximum Power Consumption at Full Power: 300W- MAINS Fuses:100~120VAC operation: MDL 3 AMP / 250 Volt SLO-BLO220~240VAC operation: MDL 1.5 AMP / 250 Volt SLO-BLO- B+ FUSES (2):MDA 1/4 AMP, 250 Volt SLO-BLO, Ceramic. (Located internally)***Only use SLO-BLO (time delay) 1 1/4” x 1/4” 3AG fuses***- Power Supply: is factory set for 100V, 120V or 220-240VAC operation for original destination country’s mains voltage.- Operating Mains Voltage: changeable with power transformer re-wiring on PCB and fuse value change.- Mains Voltage Frequency: 50~ 60Hz- Power Cord: Detachable IEC standard.- Appropriate power cord supplied for original destination country- Dimensions: W= 19”, D=14”, H= 7 1/2”- Shipping Weight: 35 lbs.19

/ 20

Related manuals for Manley Stingray II