Audio Zone Amplifier Installation GuideSystem Connection3.3.1. Safety PrecautionsThe system should be installed in a clean environment with temperature and humiditywithin the specified operating levels.All devices should be connected before turning on the power.3.2. System Diagram3.3. Audio Output3.3.1. Default output: 2x20 Watt @ 4-ohmThe default output of the Audio Zone Amplifier is 2x20 Watt with 4-ohm speakers.Please connect the amplifier output the regular way as shown in the picture below:© MuxLab Inc. 2015 7

installation guide

safety precautions

Introduction

Package Content

Specification

System Connection

Bridge connection: 1x40 Watt @ 8-ohm

Connection of Microphone

Operation of the Control Panel and the IR Remote

Using of the IR Remote

Operations of RS232 Control

Panel Drawing

Troubleshooting & Maintenance

Regulatory Compliance

MuxLab 500216 Installation Manual

500216