© MuxLab Inc. 2019 94-000862-A SE-000862-A* MMF version shown500767 3G-SDI/ST2110 over IP UncompressedGateway ConverterQuick Installation GuideOverviewThe 3G-SDI/ST2110 over IP Uncompressed Gateway Converter allows HD-SDI and 3G-SDI equipment to beextended up to 100ft (30m) via UTP Cat 6a/7 cable or up to 1300ft (400m) via duplex multimode OM4 fiberwith LC connectors, at up to 1080p resolution @ 60Hz uncompressed, in a point-to-point configuration.Point-to-multipoint and multipoint-to-multipoint configurations are also possible by connecting several unitsto a 10G Ethernet network. The unit provides a 1G Ethernet Switch port to connect additional networkdevices, and an RS232 port for remote control of end devices.The 3G-SDI/ST2110 over IP Uncompressed Gateway Converter supports SMPTE ST-2110. It can bemanaged through its Web interface and RestAPI, please refer to the operation manual for further details aboutthis.ApplicationsApplications include commercial broadcast AV systems, news/sports/TV stations and movienetworks/studios.Installation1. Identify the connectors on the Transmitter and Receiver as indicated on the product labels, see the abovefront and rear product views for further details. Note that the MMF version is shown.2. Install the SFP module, see below diagrams showing step by step instructions.3. Verify that the distance between the 3G-SDI Transmitter and Receiver is within MuxLabspecifications (see Specifications table for further details).4. To install the Transmitter:a) Connect the Transmitter to the SDI video source with a COAX cable (Belden 1694Arecommended).b) If the application is point-to-point, then connect one (1) length of Cat 6a/7 grade UTP cable tothe 10Gig port on the Transmitter. If transmitting over the network, use a 10 Gig Ethernet Switchbetween the TX & RX units.5. To install the Receiver:a) Connect the Receiver to the SDI display equipment with a COAX cable (Belden 1694Arecommended).b) If the application is point-to-point, then connect one (1) Cat 6a/7 cable coming from the