MyGate myAster 3 Installation Manual
             | |
7 11_2016PR1G13.4.3. PILLAR BRACKET T1Anchor the pivot bracket T1 onto the pillar by welding or bolting (Ø 13 mm bolts) , making sure the quotas shownin the previous table are met. Ensure to keep a minimum distance of 30 mm from the pillar edge as shown in picture H.In cases of masonry pillars, use chemical or resin to secure bolts or stone (cement) the bracket into position. Brackets T1as well are supplied in two versions, left hand and right hand and match the according motor (see picture I). Fix motorinto bracket T1 and place the pivot pin PR1 though the holes. Keep the pivot pin PR1 oriented downward. See picture L.3.4.4. GATE BRACKET S3To determine the position of bracket S3:Put the gate in closing positionRelease the operator (see paragraph 5)Extend the arm fullyTurn back the arm 2 cms. This avoids the motor to “leap forward”(pic. M)Affix the bracket S3 to the motor slot as illustrated in picture M. Place the pivot pin PR1 into the locating hole.Mount the arm of the motor onto the gate. Ensure the arm is perfectly straight.Pic. HPic. LorienteddownwardDXSXPic. IPic. NPic. MNB.Check the manual opening of the leaf beforedefinitively fixing the bracket to make sure the gatecan open fully to your required angle. |
Related manuals for MyGate myAster 3
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine