Myson 7-4 Installation & Maintenance Manual

Also see for 10-6: Installation, operating, maintenance and after sales manual

Contents

Myson 7-4 Installation & Maintenance Manual Manual pdf 4 page image

04 HI-LINE RC & HI-LINE RC Heater/Cooler5.0 PreparationBefore proceeding with the installation, unpack the cartoncontents and check against the checklist below:1. HI-LINE RC fan convector.2. 15mm isolating valves (1 pair).3. Instruction manual.4. Warranty card.5. Fixing kit (rubber mounts and cable gland).6. Remote control handset.6.0 FixingUnit A BDimensions (mm)20-14 1171 103915-10 887 75410-6 682 5507-4 554 422A27759 73B943549Fig. 1Fig. 2 Case fixing screw positionsl Using the fixing dimensions below (see fig. 1), mark the fixinghole positions on the wall.l Drill and plug the wall for No. 8 x 40mm round head woodscrews ensuring that the wall plugs are suitable for the walltype.l Remove the backing from two of the self-adhesive washersand place on two of the screws with adhesive side towardsthe point.l Tighten the screws into the top two fixing holes leaving about9mm projecting.l Press adhesive washers to the wall.l Remove the backing from the last self-adhesive washer andplace centrally over the bottom fixing hole on the left handside.Remove the outer casing as follows:l Remove the 2 screws at each end of the outlet grille (see fig. 2).l Lift off the outer case.l Fit chassis on to the top two mounting screws and tighten.l Secure the bottom fixing point with the remaining screw.Note: Before proceeding with pipe-work connections check thatthe unit is level. If the right hand end is lower than the left thenthe ability to vent the unit may be restricted.When water connections and electrical connections have beencompleted and the unit has been vented, fit the outer cover andsecure with fixing screws.