Myson SLIM-LINE RC Installation, Operating, Maintenance & After Sales Manual

Also see for SLIM-LINE RC: Installation & maintenance manual Installation, operating, maintenance & after sales manual

Contents

Myson SLIM-LINE RC Installation, Operating, Maintenance & After Sales Manual Manual pdf 3 page image

03SLIM-LINE RCmationm DesignINE RC fan convector is designed for wallwith a minimum installation height ofside of the unit.ould only be used on closed circulation,isted central heating systems, or as an be used on heat pump systems, forlearance is 4 inches.ith the installation, the heating systemsidered and the unit correctly sized toequirements of the room at normal fanheights above 10ft a ceiling fan or otheratification should be considered.l This unit is supplied with an infra red remote control systemand has 3 operating modes:Automatic - the desired room temperature is programmed into the unit and the fan speed is automatically adjusted untilthe desired room temperature is achieved.Fan only - allows user selection of any of the 3 availablefan speeds irrespective of room temperature or watertemperature in the coil.Fan only with water temperature control - allows the user toselect any of the available fan speeds, which will operate onlyif the water temperature in the coil is above 90°F. Thisenables control of the unit via an externally mounted roomthermostat if desired.be fitted on a series loop with mono-floo pipe system or as a stand alone zone.ector heating performance the systemviding sufficient hot water through theeans that:sizing both the pump and piping.e from boiler to fan convector must bed on to a system with other emitters athe fan convector should be consideredwater flow.4. The system water must be above 90°F for heating mode.5. Optimum performance of this unit will require effectivebalancing of the whole system.6. This unit should NOT be used to replace a radiator in anexisting system unless an adequate flow of water can beguaranteed through the unit.7. The loop must be pumped. HI-LINE fan convectors are notsuitable for gravity circulation systems./Sizingce is given in the Technical Data sections are shown for the three fan speeds,t to size the unit to match the calculatedof the room with the unit operating onhigher fan speeds are used in automaticmperature is significantly lower than theWhen establishing the temperature difference, i.e. enteringwater to room temperature, allowance should be made fortemperature drop in the system. It is the water temperature atthe unit which dictates the output.it may be fitted to any convenient wallfloor level that suits the application,ded flow of warm air into the area to bece from the underside of the unit to floorl The unit should be mounted on a flat wall, and stud orpartition walls should be avoided to minimise the possibilityof noise transmission.1.02.03.04.0