NAD C275BEE Owner's Manual

Also see for C275BEE C/AH: Datasheet Owner's manual Service manual User manual

Contents

NAD C275BEE Owner's Manual Manual pdf 6 page image

1 STANDBY BUTTON: Press this button to switch ON the C 275BEE.The Standby LED indicator will turn from amber to blue. Pressing theSTANDBY button again turns the unit back to standby mode.IMPORTANT NOTICEThe rear panel POWER switch must be in the ON position for theSTANDBY button to activate.2 STANDBY LED: This indicator will light up amber when the C 275BEEis in standby state. When the C 275BEE is at ON state, this indicator willilluminate blue.In cases of serious abuse of the C 275BEE, such as excessively lowloudspeaker impedance and short circuit, the C 275BEE will engage itsProtection circuitry, indicated by the Standby LED turning from blue tored and the sound being muted.In such a case, turn the C 275BEE OFF by the rear panel POWER switch,wait for it to cool down and/or check the speaker connections, makingsure the overall loudspeaker impedance doesn’t go below 4 ohms or8 ohms in Bridge mode. Once the cause for the protection circuitry toengage has been removed, switch ON the rear POWER button and theStandby Button to resume normal operation.3 BRIDGE MODE INDICATOR: This BRIDGE MODE indicator lights upblue when the C 275BEE is switched to Bridge Mode. Refer also to theitem below about BRIDGE MODE at the IDENTIFICATION OF CONTROLS– REAR PANEL.4 SOFT CLIPPING INDICATOR: The blue SOFT CLIPPING LED showsthat the SOFT CLIPPING mode is engaged. Refer also to the item belowabout SOFT CLIPPING at the IDENTIFICATION OF CONTROLS – REARPANEL.IDENTIFICATION OF CONTROLSFRONT PANEL1 2 3 46ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ