NAD C565BEE Owner's Manual

Also see for C565BEE: Datasheet Service manual

Contents

NAD C565BEE Owner's Manual Manual pdf 12 page image

USB MODEThe C 565BEE can play back MP3/WMA files stored in external USB(Universal Serial Bus) devices. The following are the C 565BEE’s capabilitieswith respect to USB device playability.USB SUPPLEMENTARY INFORMATIONMaximum number of folders supported 128Maximum file in one folder 511Maximum file in device 65408Maximum number of sub-directory 8Maximum number of bytes supported for Folder/File name 64Maximum number of bytes supported for ID3 Title/Artist/Album 60Maximum bit rate supported VBR, 320KHDD handling capacity (additional power adapter maybe required forsome HDD models) FAT 16/32USB version supported 1.1LISTENING TO USB DEVICE1 Toggle [SOURCE] button to select “USB” mode. If no external USB deviceis connected to the front panel’s USB input, “No USB” will be displayedin the VFD. If there are no applicable MP3/WMA files available in theexternal USB, the VFD will show “USB Empty”.2 Plug-in the external USB device to the USB input – “USB Reading” will beblinking in the VFD and then the total number of files will displayed.3 Press [ ] to start playback.SELECTING DIRECTORIES OR FILESThe following are the steps on how to select a desired directory and MP3 orWMA file at stop mode.1 Connect the external USB device to the front panel’s USB input. Toggle[SOURCE] button to select “USB” mode.2 Press [FOLDER ] to select desired folder. Press [ENTER].3 Press [FILE ] to select desired file number.4 Press [ENTER] to start playback. Toggle CD 9’s [DISP] button to showinformation about the current file. Refer also to the item about DISPLAY atthe FRONT PANEL section of the IDENTIFICATION OF CONTROLS page.NOTEDo not disconnect the USB flash drive during playback. It may causedamage to the C 565BEE.OPTICAL INPUT MODEThe C 565BEE is equipped with an optical digital input. This makes itpossible for other external digital sources to make use of C 565BEE as a topquality digital-to-analog converter. The C 565BEE accepts audio data only atthis optical input port and can handle up to 192 kHz/24 bit signals.LISTENING TO OPTICAL INPUT1 Toggle [SOURCE] button to select “Optical Input” mode. If no sourcecomponent is connected at the rear panel OPTICAL DIGITAL AUDIOIN port or if the source is not supplying a signal, the VFD will display“UNLOCKED”. If the source supplies a non-valid data such as compressedformat, Dolby Digital or DTS audio signal, the VFD will display “NotSupport”; only audio data is supported.2 When the C 565BEE detects a valid digital audio input, the VFD willshow the audio format and the current sample rate. Toggle CD 9’s [SRC]button if you would like to change the sample rate of the input signal.3 Audio available from the connected external digital source will now bethe active input.OPERATIONUSING THE C 565BEE – USB AND OPTICAL INPUT MODE12ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ