NAD HP70 Owner's Manual
        | |
INCLUDED ACCESSORIES1 HEADPHONE ADAPTOR CABLEFor a complete listening experience on most devices not wirelesslysupported, use the standard ribbon cable. Plug the straight end of thestandard cable into the bottom of the right ear cup and the L-shaped endinto the 1/8” (3.5mm) stereo socket on your music player.• Each ear cup is marked with “L” and “R” to indicate the left and rightsides of the headphones.• A 1/4" (6.3mm) adaptor is also included for connecting to otheraudio equipment.NOTES• Hold the plug at the end of the cable and pull to disconnect. Never pullon the headphone cable to disconnect the headphones from the musicplayer.• Turn the volume down to a comfortable listening level on your musicplayer before putting on VISO HP70.2 AIRLINE ADAPTOR• Use the supplied dual 3.5mm airline adaptor to connect your VISOHP70 to in-flight stereo entertainment systems.NOTES• The supplied conversion plug may not be usable depending on the typeof aircraft.• Do not use these headphones when the use of electric devices on theaircraft is prohibited, or when the use of personal headphones to listento on-board music service is prohibited.• Audio output jack configurations may vary on airplanes. Airline audioquality may not equal that of your home audio equipment, or portablesources provide.NAD recommends not to use these headphones as aviationcommunication equipment. They are not engineered for manyenvironmental conditions common in commercial or non-commercialaircraft (including, but not limited to: altitude, temperature, noiseconditions, unpressurized aircraft) and could result in possibleinterference to critical communications.3 USB CABLE• Use the supplied USB cable to listen to music from you computer(audio only). This cable is used to charge your HP70 headphones.Notes:• When connecting the USB cable to the charging port, be sure to matchthe cable connector with the shape of the socket. Forcing the connectorinto the socket will cause damage.• A rating of the charging output should be DC 5V, 2.4A or less• -The usable time of the headphones differs depending on thetemperature of the environment in which they are used and method oruse.Wireless PairingPairing is the process required to create a link between Bluetooth devicesto allow wireless connection. You must pair a device with the HP70headphones to be able to make a BLUETOOTH connection for the first time.Before you start pairing operation, make sure that:• The Bluetooth device is placed within 1 m (3 feet) of the headset.• The HP70 is charged sufficiently.To pair your device:1. Turn on the Bluetooth feature on the source device.2. Open the Bluetooth settings on the source device.3. Press the pairing button for 3 seconds on the HP70. The LED will flashBLUE.4. Select the HP70 headphones from the device list.5. Once the HP70’s link has been established with the source device, theLED will turn solid BLUE.6. If pairing fails, the LED will turn solid RED.NFC Wireless PairingHP70 supports Near Field Communication (NFC) so you can easily pair yourheadphones. For pairing follow the instructions below.To pair your device using NFC:1. Turn on NFC and Bluetooth on the device you are pairing.2. Place your Bluetooth enabled device against the bottom of the rightear cup.3. Accept the pairing on your device when prompted.Note: NFC is a short-range wireless communication. Pairing devicesare required to be within a few centimetres of the headphones tocommunicate. If pairing is unsuccessful, refer to the device’s manual tofind its NFC touchpoint. Repeat the steps shown and ensure the locatedtouchpoint is placed against the right ear cup as directed in Step 2.WIRELESS PAIRING4ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ |
Related manuals for NAD HP70
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine