NAD L75 Owner's Manual

Also see for L75: Service manual

NAD L75 Owner's Manual Manual pdf 11 page image

GB11AUDIO OPERATIONSBASIC OPERATIONS1 Press the POWER button to ON.2 Adjust the tone as required with the BASS and TREBLE tone controls. Adjust the balance between theleft and right channels with the BALANCE control.3 Select the desired source with the Source Selector. An indicator for the selected source lights up.4 Select the desired surround mode with the SURROUND MODE buttons. (The SURROUND indicatorlights in the display.)• Refer to available surround modes. (page 12).• Refer to OSD surround mode. (page 16-17).5 Start playing the source component.6 Gradually turn up the volume to the required level with the MASTER VOLUME control.1 POWER STANDBY/ON Button Press this button to turn the power on. Press it again to turn thesystem off (power standby mode). The STANDBY indicator lights up in power standby mode and goesout when this unit is turned on.2 BASS/TREBLE Tone Controls These two tone controls - BASS and TREBLE - can be used to obtain a“flat” frequency response or a tone which suits your individual listening preference. The Bass controladjusts low frequencies and the TREBLE control adjusts the high frequencies.3 BALANCE Control This control is used to adjust the balance between the left and right channels.Normally set to the center position.4 MASTER VOLUME Control Adjust the overall sound volume from the front, center, sub woofer andrear speakers with this control.5 FM MUTE/MONO This button combines two functions, it switches the tuner from stereo to mono anddisengages the mute circuitry at the same time. The muting circuit will mute the Tuner in between radiostations when searching or tuning. If FM broadcasts with weak signal strength are received, the FMmuting function works automatically to cut the signals, eliminating loud noise.6 SURROUND MODE Button Surround mode changes follows whenever you press this button.• Refer to available surround modes. (page 12)• Refer to OSD surround mode. (page 16-17)NOTE• You can not select DTS/DOLBY DIGITAL mode in Analog mode or except DVD, AUX Function.• To select DTS/DOLBY DIGITAL mode, you should select optical or coaxial mode by DISPLAY button.7 DISPLAY Button Press this button to switch the digital signal when DVD, AUX selected. Refer to OSDdigital input (page 16).When DVD selectedWhen AUX selectedCAUTIONIn tuner function, this button toggles the display to show the PS/RT.2 2 31 6 42 341 765AUDIO ADJUSTMENTSOptical Coaxial AnalogOptical Analog