• Low noise, wide band MC/MM phono stage• Connect your turntable to most amplifiers and receivers• External 23.5V DC power supply• Gold plated input sockets• LED power indicator• High quality componentsSETUPA CONNECT TURNTABLE TO PP 2e1 Ensure all ancillary equipment is turned off and the NAD PP 2e not yetconnected to its dedicated power Supply.2 Connect the leads from the turntable to the appropriate input socketson the back of the NAD PP 2e - MC for moving coil, MM for movingmagnet cartridge. Make sure you connect the Right channel to theRight input; the Left channel to the Left input. Normally, red connectordenotes the Right Channel; white denotes the Left channel.3 Once the turntable leads are connected, set the MC/MM switch on theback of the NAD PP 2e to the correct input setting.B CONNECT PP 2e TO AN AMPLIFIER OR RECEIVER1 Connect suitable RCA leads from the NAD PP 2e to the amplifier orreceiver. Always use a so-called “Line-Level” input such as CD, AUX orDISC. Never connect the lead from the NAD PP 2e to an input markedPHONO or turntable.2 Again, make sure to connect the red plug to the Right channel, and thewhite plug to the Left channel of the amplifier or receiver.3 If the lead from your turntable is equipped with a separate earth (GND)lead, connect this directly to a ground connection on the NAD PP 2e.Use the thumb screw terminal “GND” which provides the grounding.C CONNECT THE POWER SUPPLY TO THE PP 2e1 Connect the dedicated Plug-in Power Supply to the NAD PP 2e(marked 23.5V).2 Insert the Plug-in Power Supply to a live mains socket; the blue LED onthe NAD PP 2e’s front panel will light up. Installation is now complete.As the power consumption of the NAD PP 2e is negligible, it can always beleft switched on. It is recommended however that you disconnect the Plug-in Power Supply from the mains if you are not going to use the NAD PP 2efor a prolonged period of time (such as a holiday).D OPERATION1 With setup completed and the NAD PP 2e plugged in to a live mainssocket, power up the turntable and the amplifier or receiver the NADPP 2e was connected.2 Ensure that the amplifier or receiver is set to the source or input wherethe NAD PP 2e is connected and start playback of a vinyl record in theturntable.3 Adjust the volume level of the amplifier or receiver accordingly.®PHONO PREAMPLIFIER PP 2eUser Guide