NAD T 777 Owner's Manual

Also see for T 777: Quick setup guide Owner's manual Quick setup guide

NAD T 777 Owner's Manual Manual pdf 45 page image

The T 777 has the capability to operate via Alternate IR channel. This ispractically useful if you have two NAD products that can be operated bysimilar remote control commands. With alternate IR Channel, two differentNAD products can be controlled independently in the same zone bysetting each one to a different IR channel.IR CHANNEL ASSIGNMENTThe T 777 and the HTR 8 remote control must be set to the same channel.To change the Main Zone IR Channel on the T 777r Press and hold [ a SOURCE ] and then toggle STANDBY button to selectdesired IR Channel – the VFD will show “IR Channel 1” or “IR Channel 0”.The default IR Channel is “IR Channel 0”.To change the IR Channel on the HTR 8 remote controlr Include a channel number before the library code. For HTR 8, librarycode “100” is the default library table for “AMP” device. To select this“AMP” library table for “IR Channel 0”, retain the library code “100”.r If you want to load the “AMP” library table on “IR Channel 1”, prefix thelibrary code with “1” to indicate association with “IR Channel 1”. Loadthen the “AMP” library table using the code “1100”.SAMPLE SETUP OF TWO NAD PRODUCTS ON THE SAME ZONENAD T 777 and NAD C 326BEE are both defaulted to IR Channel 0. If [OFF]button is pressed on the HTR 8 remote control (or SR 8 remote control forthe C 326BEE), both products will go to standby mode. Press [ON] and bothproducts will power up from standby mode.To prevent both products from simultaneously going in and out of standbymode along with other common commands, set each one to a differentIR channel. In this setup, we will keep C 326BEE and SR 8 remote controldefaulted to “IR Channel 0”. As for T 777, we will assign it to “IR Channel 1”;the same applies to HTR 8.Set T 777 and HTR 8 to “IR Channel 1” via the following procedure.T 777r Press and hold [ a SOURCE ] and then toggle STANDBY button toselect “IR Channel 1”.HTR 8Begin by ensuring that the T 777 is powered-up (“on”, not merely instandby).r To enter HTR 8’s library mode, press and hold both the [AMP] deviceand [A/V PSET] until the LEARN LED turns green.r While keeping the HTR 8 pointed towards the T 777, enter thelibrary code “1100”. Press [OFF]. If the T 777 goes to standby mode,press [ENTER] to accept the library code number and exit librarymode.With both T 777 and HTR 8 set to “IR Channel 1”, the C 326BEE can now beremotely controlled independent of the T 777.NOTEPerforming a Factory Reset for T 777 or HTR 8 will result to a return to thefactory default “IR Channel 0” setting.OPERATIONUSING IR CHANNEL45ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ