|
2 To select other channels, toggle [ ] to step through the channel list.Release [ ] when you have arrived at your desired channel. Press[ENTER] to tune the selected channel.• Channel and frequency are shown in the lower line of the VFD.The number of “o” display at the upper line of the VFD indicatesthe signal strength level of the current channel. To improve thereception of the selected channel, adjust or reposition the DABantenna until the best reception is indicated.ooooo������������5A��174.928MHz�• If the manually tuned channel and frequency are not available, “NoService List” will be shown in VFD.NOTEThe number of ensembles and stations that could be scanned will varydepending upon your location.PRUNE LISTThere maybe situations wherein certain stations become inactive. The“Prune list” option enables the deletion of these inactive stations in theservice list.1 While listening to a DAB broadcast, press [TUNER MODE] button andthen [ ] to select “Prune list”.DAB�������������2 Press [ENTER]. Use [ ] and then press [ENTER] to select between“Cancel” or “OK? [SELECT]”. Any inactive stations (normally preceded bya “?” mark) are automatically deleted when “OK? [SELECT]” is selected.Otherwise, select “Cancel”.DAB�������������DAB RESETThe “DAB reset” option enables the re-initializing of the NAD DAB Adaptorby going to Full Scan mode.1 While listening to a DAB broadcast, press [TUNER MODE] button andthen [ ] to select “DAB reset”. Press [ENTER].DAB�������������2 The VISO THREE will initiate “DAB reset” and immediately go on to “FullScan” mode thereby enabling the VISO THREE to re-scan again the fullrange of available DAB broadcasts.IMPORTANT NOTICEWhen “DAB reset” option is selected, all stored DAB presets will beerased.SETTING DAB PRESETSThe VISO THREE can store as many as 99 DAB stations of your favorite DABbroadcast for immediate recall.1 To store a DAB preset, first tune the DAB broadcast, and then press theVR 3’s panel [MEMORY] button (DEVICE SELECTOR must be set “TUN”).The VFD will show “Preset Memory --”; “--” is blinking waiting for a Presetnumber to be assigned.2 Enter a Preset number in two ways- Directly enter a number between 1 to 99 and then press [MEMORY]button.- Toggle [ ] or PRESET [ ] to step through the Presetnumbers, stop at desired number and then press [MEMORY].Your desired DAB broadcast is now stored in the assigned preset.DAB�������������Preset�memory�013 Press [ ] or PRESET [ ] to step up or down betweenpresets. Stop at desired Preset number. Note that Presets must havebeen previously stored.DELETING A DAB PRESETThe procedure for deleting a DAB preset or all DAB Presets is the same asthat of deleting AM/FM Presets.OPERATIONLISTENING TO DAB RADIO21ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
|
