NAPCO XP-600 Express Series User Manual

Also see for EXPRESS XP-600: User manual Installation instructions Datasheet User guide User guide

Contents

NAPCO XP-600 Express Series User Manual Manual pdf 11 page image

Your Installer has assigned a User 1 Code which may be used to not only Arm and Disarm the system, butalso to enter the User Program Mode, where you can program other user codes. The following explains howyou will use this code to program or erase additional user codes.Entering the User Program ModePress followed by and then enter the User 1 code. The Armed, Status and 9System Lights willflash, and the keypad will beep 4 times. You are now in the User Program mode. Zone lights 1 through 6will light to indicate any User Codes presently programmed.Programming / Reprogramming User Codes1 Press the User number to be programmed. (For example, press to program the User 2 code.).The keypad will beep 2 times and the corresponding Zone light will flash to indicate the usernumber you are about to program.2 Press in the 4 digits of the new User 2 code, the keypad will beep 4 times.3 If there are more user codes to be programmed, return to step 1 above, otherwise, go to Exiting theUser Program Mode below.Erasing a User Code1 Press the User number to be erased. The keypad will beep 2 times and the corresponding Zone lightwill flash to indicate the user number you are about to erase.2 Press . The zone light will go out to indicate that the user code has been erased.3 If there are more user codes to be erased, return to step 1 above, otherwise, go to Exiting the userProgram Mode below.Exiting the User Program ModeWhen you are done programming or erasing User codes, press " to Exit the User Program Mode.Programming User CodesFIREACSYSTEMREADYZONE 3ZONE 1ZONE 2ZONE 5ZONE 6ZONE 4ARMED14www.ealarm.com.my

/ 11

Related manuals for NAPCO EXPRESS XP-600