NCD Explora 700 Installing Manual
                                            | |
Contents
| 
Installing Additional MemoryInstalling Optional Equipment 5-92. Lower the front of the top section until the three tabs slide through thethree slots on the bottom section.3. Replace the front control panel.4. Replace the PCMCIA card if appropriate. See “Installing PCMCIA Cards”on page 5-11.5. Install the cabling. See Section 3, “Basic Installation,” on page 3-1.6. After the system is installed, perform the memory test. See “TestingMemory.”Testing MemoryThe NC must be installed before you can run the memory test. Afterinstallation, you can access the Boot Monitor to run the memory test.Accessing the Boot Monitor1. Turn on the system or reboot (if the system is already on).2. After the Boot Monitor title and version number, messages similar to thefollowing appear. Press the Escape key to interrupt the booting process.Searching for IP address...Using IP addressIP address of terminalSearching for subnet maskUsing subnet masksubnet mask...........................(Press Escape to interrupt booting.)>Memory TestRun the memory test as follows:1. Type a question mark and press the Return key to find the command forExtended Tests.> ? |
Related manuals for NCD Explora 700
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine