Manuals database logo
manualsdatabase
Your AI-powered manual search engine

NCD NC200 Installation Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Contents
  1. safety summary
  2. kit contents
  3. system requirements
  4. troubleshooting
NCD NC200 Installation Manual Manual pdf 6 page image
Floppy Disk Drive Installation2 Floppy Disk Drive InstallationSystem RequirementsTo connect the floppy drive to your NC, you must have a Parallel Port installed.If you do not have a Parallel Port installed, contact your NCD distributor orsales representative. In addition, your NC must be operating with NCBridgeSoftware Version 3.2 or later.Connecting the Drive1. Connect the drive to the NC’s parallel port. Refer to the drawing in Figure 1.Look at the plugs on the interconnect cable. The plug that has pins connectsto the NC; the plug that has holes connects to the floppy drive.2. Connect the power supply to the floppy drive as shown.Now you are ready to make the connection to the network described on page 4.
/ 18
This manual is suitable for:
NC200NC400NC900
Manuals database logo
manualsdatabase
Your AI-powered manual search engine