Chapter 5: Initial Terminal ImagingIntroductionFactory default HDD/SSD images for the RealPOS XR7 POS are distributed on bootableauto-imaging USB Flash Drive media. The following procedures describe how toapply/restore an image on the terminal.Warning: Using this procedure will replace any previously stored OS imagescreated using the Disk Image Backup and Recovery Tool.Note: A USB Keyboard is required to perform this operation.Imaging Procedure1. Connect the USB flash drive to the target terminal that you wish to image.2. Connect a USB keyboard to the terminal.3. Power on the terminal and boot from the USB Flash Drive. This can be done bypressing F8 during the boot and choosing the USB option (NCR), or by enteringBIOS Setup and changing the boot order.4. The system boots in the Windows PE OS environment. Press Y on the keyboard atthe confirmation prompt to re-image the terminal.5. When the imaging process is complete, enter Exit on the keyboard to reboot thesystem.6. After the reboot, remove the USB Flash Drive and disconnect the keyboard.
