111Cirrus LT User Manual v2.3 - Chapter 6Chapter 6: Making remoteconnectionsYou can connect to a remote machine using the Teradici Firmware. Basic directions are in-cluded below, but you can find more detailed information in the Teradici PCoIP Zero Clientand Host Administrator Guide.*Connecting to remote machines with Teradicihost cardsTo set up a remote connection between your device and a remote machine, youneed an enterprise-level NAT device in both the source and destination networks.Otherwise, your remote host would need an internet routable IP address.To connect to a remote machine:1. Configure the enterprise NAT device to redirect TCP/UDP port 4172 to thehost card.2. From the device’s Teradici menus, configure the Direct to Host session con-nection type, and enter the IP address of the destination enterprise NATdevice.3. From the host card’s AWI, configure the Direct from Client session connec-tion type.4. On your firewall or router, allow both TCP and UDP traffic on the ports youhave configured in your NAT devices.5. Start a PCoIP session.
