NComputing N400 User Manual

Also see for N500: User manual User manual

Contents

NComputing N400 User Manual Manual pdf 5 page image

NComputing N-series User Manual rev11.09.12Page 5 of 25GPL DeclarationsThe NComputing N-series access device contains – in part – some free software (software licensed in away that ensures your freedom to run, copy, distribute, study, change and improve the software). Thisfree software is also contained in the N-series firmware update files that are distributed online. The freesoftware contained within the N-series firmware includes a version of X-LOADER, U-BOOT, LINUX,LIBSYSFS, LIBUCI, LIBUSBIP, ETHTOOL, UCLIBC, QT and BUSYBOX.Further, for at least three (3) years from the date of distribution of the applicable product or software,we will give to anyone who contacts us at gplcoderequest@ncomputing.com, for a charge of no morethan our cost of physically performing source code distribution, a machine-readable copy of thecomplete corresponding source code for the version of the software that we distributed to you. Foradditional information refer to this page on the NComputing website:www.ncomputing.com/gplcodedownloadSafety InformationRefer to the following to prevent any physical injury or loss of assets caused by damage to the product.A user must read this User Manual carefully before use and properly follow the instructions. Make sure that the place of installation is not too hot (above 35˚C), too cold (below 0˚C), or toowet (above 85% relative humidity). Avoid any severe impacts to the product Make sure that the product is not exposed to direct sunlight or any hot machinery. Please keep the product away from any items which have strong magnetic properties. Do not disassemble, repair or rebuild the product. Please properly route all cables and power cords to avoid a tripping hazard. An electric shock,fire, damage to the product or physical injury may occur as a result of tripping over the cable.